Comments on: Playchoice Control Panel Overlay Has Arrived!

By: Eric Bousquet

Eric Bousquet — Sun, 17 Jan 2010 17:47:21 +0000

I ordered this same CPO from Arcade Overlays and am about to apply it. I think the key is using heat on the bends. I also ordered a POPEYE sideart set and wasn’t totally pleased. it was clearly injet printed because if you look close you can see the art pixelated…which I don’t really like AT ALL! But it was the only set I could find at the time and I was running out of time on the restor and had to move onto this PLAYCHOICE 10 cab.
I’d say avoid Arcade Overlays if you can but only because of the injet, the material overall was not bad.

By: Matt

Matt — Tue, 14 Apr 2009 07:02:14 +0000

So, how did your CPO look or did it ever get installed?

By: Ben

Ben — Fri, 19 Dec 2008 18:37:39 +0000

I am definitely interested to hear how well it adheres to th CP. After this initial post I realized that’s it’s possible that my CP already has this CPO on it. If so, it either wasn’t applied very well or the adhesive is coming up anywhere there is a bend in the CP. It’s loose on the front, at the indent where it angles upwards, and at the bend from up to flat on the top section. Might require using an additional adhesive or something but the one I have is definitely cracking and coming apart pretty bad on that front bend.

By: Jeff R.

Jeff R. — Thu, 18 Dec 2008 02:35:01 +0000

This is great that you are writing a direct user review / feedback of the quality of arcade game products from Arcade Overlays. You are brave to test the waters where others might not have been…

You can edit this line out if you like….but we’ll see now if your subscribe to comments is working just like it should be.